Dodge RAM TRUCK 1500 1995 Service Manual page 1554

B R
42RH/46RH/47RH OVERDRIVE UNIT OVERHAUL ' 21 - 273
SPECIAL
TOOL
6227-
CLUTCH
DRUM
J9221-3
DIRECT
CLUTCH
PLATES/DISCS
Fig. 61 Seating Clutch Pack In Drum
SPECIAL
TOOL
C-6227-2
DIRECT
CLUTCH
PACK
SNAP
RING
IJ9221-4
Fig. 62 Direct Clutch Pack Snap Ring Installation
SPECIAL
TOOL
C-6227-2
CLUTCH HUB
RETAINING RING
J9221-5
Fig. 63 Clutch Hub Retaining Ring Installation
OVERDRIVE GEARTRAIN AND CASE ASSEMBLY
(1) Install front bearing and snap ring on output
shaft (Fig. 64). Be sure locating ring groove in
bearing is toward rear of shaft. Otherwise,
housing locating ring and bearing ring groove
will not align. Remove and reposition bearing if
necessary.
(2) Install governor drive key in output shaft (Fig.
64). Use petroleum jelly to hold key in place if neces­
sary.
OUTPUT
SHAFT
DRIVE
KEY
FRONT
BEARING
SNAP
RING
II J9521-76
Fig. 64 Front Bearing And Drive Key Installation
(3) Install governor body and drive assembly on
output shaft as follows (Fig. 65).
(a) Be sure drive key is fully engaged in shaft
drive slot.
(b) Align key with slot in governor drive and
slide drive assembly into place. To avoid displacing
drive key, reach through weight opening in gover­
nor body with fingers and guide key into place.
DRIVE
KEY
GOVERNOR
ASSEMBLY
J9221-41
Fig. 65 Governor Assembly Installation
(4) Install governor weight assembly in governor
body (Fig. 66).
(5) Install retainer washer and snap ring that se­
cure governor weight assembly in governor body (Fig.
67).
(6) Verify that governor valve shaft bores in gover­
nor body and output shaft are aligned.
(7) Install governor valve in body bore. Large di­
ameter end of valve faces outward. Then install gov­
ernor valve shaft and secure it with E-clips.