I -111
§ J L ENGINE
BR
(8) Remove the cooling system fan.
(4) Remove the serpentine belt (refer to Group 7,
Cooling System).
(5) Remove crankshaft pulley/damper bolt and
washer from end of crankshaft (Fig. 2).
J9409-138
Fig. 2 Crankshaft
Pulley—Damper
(8) Using a 3-prong puller tool, pull pulley—
damper off of the crankshaft.
(7) Inspect crankshaft oil seal (Fig. 8).
INSTALLATION
(1) Position the crankshaft pulley/damper onto the
crankshaft.
(2) Use tool C-3688 to press the pulley/damper
onto the crankshaft. Install crankshaft bolt and
washer and tighten to 188 N-m (185 ft. lbs.) torque
(Pig.3).
(8) Install the serpentine belt (refer to Group 7,
Cooling System).
(4) Install the cooling system fan. Tighten the bolts
to 28 N-m (17 ft. lbs.) torque.
(6) Position the fan shroud and install the bolts.
Tighten the bolts to 11 N-m (95 in. lbs.) torque.
(6) Connect the negative cable to the battery.
T H U G CHAIN COWER
REMOVAL
(1) Disconnect the negative cable from the battery.
(2) Drain cooling system (refer to Group 7, Cooling
System).
(3) Remove the serpentine belt (refer to Group 7,
Cooling System).
(8) Remove fan shroud.
(4) Remove fan.
J9409-142
Fig. 3 Installing Crankshaft
Pulley—Damper
(4) Unbolt A/C compressor and set on top of en
gine.
(6) Remove generator, air pump, and bracket as
sembly.
(5) Remove water pump (refer to Group 7, Cooling
System).
(7) Using a 3-prong puller to remove pulley/
damper from the crankshaft.(Fig.4)
J9409-138
Fig. 4 Pulley—Damper
Removal