Dodge RAM TRUCK 1500 1995 Service Manual page 1531

21 - 250 46RH/47RH TRANSMISSION OVERHAUL
(g) Tighten band adjusting screw only enough to
hold strut in place (Fig. 157).
Fig. 157 Rear Band Lever Adjusting Screw (47RH)
PLANETARY GEARTRAIN, FRONT/REAR
CLUTCH, AND FRONT BAND INSTALLATION
(1) Install assembled intermediate shaft and plan­
etary gear components (Fig. 158). Support shaft
carefully during installation. Do not allow shaft
bearing/bushing surfaces to become nicked or
scratched.
INTERMEDIATE SHAFT
A N D
PLANETARY
' GEAR TRAIN
ASSEMBLY J9121-508
Fig. 158 Intermediate Shaft/Planetary Geartrain
Installation
(2) Lubricate intermediate shaft thrust plate with
petroleum jelly and install plate on shaft pilot hub
(Fig.
159).
(3) Check input shaft front seal rings, fiber thrust
washer and rear seal ring (Fig. 160). Be ends of rear
seal ring are hooked together and diagonal cut ends
of front seal rings are firmly seated against each
other as shown. Lubricate seal rings with petroleum
jelly after checking them.
SHAFT
THRUST
PLATE
INTERMEDIATE
SHAFT PILOT
^ HUB
i
Fig. 159 intermediate Shaft Thrust Plate installation
FRONT
SEAL
RINGS
REAR ^
SEAL I'"
RING i
il:f"
j J f 121-102 s
Fig. 160 Input Shaft Seal Ring And Thrust Washer
Installation
(4) Assemble front and rear clutches (Fig. 161).
Align lugs on front clutch discs. Mount front clutch
on rear clutch. Turn front clutch retainer back and
forth until front clutch discs are fully seated on rear
clutch splined hub.
(5) Install intermediate shaft thrust washer in hub
of rear clutch retainer (Fig. 162). Use petroleum jelly
to hold washer in place. Position washer so grooves
are facing outward. Washer only fits one way in
clutch retainer hub.
(6) Place transmission case in upright position, or
place blocks under front end of transmission repair
stand to tilt case rearward. This makes it easier to
install front/rear clutch assembly.