Dodge RAM TRUCK 1500 1995 Service Manual page 1523

21 - 2 4 2
46RH/47RH TRANSMISSION OVERHAUL
(b) Hold shuttle valve in place.
(c) Compress secondary spring and install E-clip
in groove at end of shuttle valve.
(d) Verify that spring and E-clip are properly
seated before proceeding.
(7) Install shuttle valve cover plate. Tighten cover
plate screws to 4 N-m (35 in. lbs.) torque.
(8) Install 1-2 and 2-3 valve governor plugs in
valve body.
(9) Install shuttle valve primary spring and throt­
tle plug.
(10) Align and install governor plug cover. Tighten
cover screws to 4 N-m (35 in. lbs.) torque.
(11) Install manual valve.
(12) Install throttle valve and spring.
(13) Install kickdown valve and detent.
(14) Install regulator valve.
(15) Install switch valve.
Boost Valve Tube And Brace Installation
(1) Position valve body assembly so lower housing
is facing upward (Fig. 130).
(2) Lubricate tube ends and housing ports with
transmission fluid or petroleum jelly.
(3) Start tube in lower housing port first. Then
swing tube downward and work opposite end of tube
into upper housing port (Fig. 131).
(4) Insert and seat each end of tube in housings.
(5) Slide tube brace under tube and into alignment
with valve body screw holes (Fig. 131).
(6) Install and finger tighten three screws that se­
cure tube brace to valve body housings (Fig. 131).
(7) Bend tube brace tabs up and against tube to
hold it in position (Fig. 132).
(8) Tighten all valve body housing screws to 4
N-m (35 in. lbs.) torque after tube and brace a r e
installed. Tighten screws in diagonal pattern
starting at center and working outward.
\ BOOST
\ VALVE
TUBE
TUBE
BRACE J9521-107
Fig. 131 Boost Valve Tube And Brace Installation
BEND TABS
UP AGAINST
TUBE AS SHOWN J9521-108
Fig. 132 Securing Boost Valve Tube With Tube
Brace Tabs
3-4 Accumulator Installation
(1) Position converter clutch valve and 3-4 shift
valve springs in housing (Fig. 133).
(2) Loosely attach accumulator housing with right-
side screw (Fig. 133). Install only one screw at this
time as accumulator must be free to pivot upward for
ease of installation.
(3) Position plug on end of converter clutch valve
spring. Then compress and hold springs and plug in
place with fingers of one hand.
(4) Swing accumulator housing upward over valve
springs and plug.
(5) Hold accumulator housing firmly in place and
install remaining two attaching screws. Be sure
springs and clutch valve plug are properly seated
(Fig. 134).
RIGHT-SIDE SCREW
3-4 ACCUMULATOR
Fig. 133 Converter Clutch/3-4 Shift Valve Spring
Installation