Dodge RAM TRUCK 1500 1995 Service Manual page 1657

23 - 32 INTERIOR COiPONENTS
BR
SPLIT BENCH SEAT
REMOVAL
(1) Move seat track to forward position.
(2)
Hinge
seat back forward.
(3)
Disengage
power
seat wire
connector
from
body
harness, i f equipped (Fig. 7).
SEAT
Fig. 7 Split Bench Seat
(4) Remove nuts holding outboard and inboard
tracks to floor (Fig. 7).
(5) Move seat track to forward position.
(6) Remove bolt holding inboard seat track to bot­
t o m of center occupant seat.
(7) Remove bolts holding front of seat tracks to
floor.
(8) L i f t center occupant seat u p w a r d to clear rear
attachment stud.
(9) Separate seat from vehicle.
INSTALLATION
(1) Position seat i n vehicle.
(2) I n s t a l l bolts holding front of seat tracks to floor.
Tighten the bolts w i t h 28 N-m (250 in-lbs) torque.
(3) I n s t a l l bolt holding inboard seat track to bot­
t o m of center occupant seat. Tighten the bolt w i t h 28
N-m (250 in-lbs) torque.
(4) I n s t a l l nuts holding outboard and inboard
tracks to floor. Tighten the nuts w i t h 40 N-m (30 ft.
lbs.) torque.
(5) Connect power seat w i r e connector to body har­
ness, i f equipped (Fig. 7).
SEAT REPAIR—SPLIT BENCH
DISASSEMBLY
(1) Remove seat from vehicle.
(2) Remove center seat/console armrest (Fig. 8).
(3) Disconnect power seat switch connector, i f
equipped (Fig. 9).
(4) Remove seat tracks (Fig. 10 and 11).
(5) Separate seat back from seat cushion (Fig. 12).
J9523-156
Fig. 8 Split Bench Seat Disassembly
J9523-159
Fig. 9 Power Seat Switch
Fig. 10 Power Seat Track Removal/Installation
SEAT
BACK COVER
R E M O V A L
(1) Using a t r i m stick or equivalent tool p r y off
lumbar handle, i f equipped (Fig. 13). (Damage to
lumbar handle may occur d u r i n g removal,
verify
availability of replacement handle before removing.)