Dodge RAM TRUCK 1500 1995 Service Manual page 1256

B R
STEERING 11 -13
PUMP
RETURN HOSE
P R E S S U R E
H O S E
ENGINE BLOCK
LOWER PUMP
ASSEMBLY BOLT
CLAMP
STEERING
GEAR
J9519-72
Fig. 3 Power Steering Hose Gas Engine
(6) After installation, inspect and test for fluid
leaks.
PUMP REPLACEMENT—DIESEL ENGINE
REMOVAL
(1) Place a drain pan under the power steering
pump.
(2) Disconnect and cap the vacuum and steering
pump hoses.
(3) Disconnect the electrical connector on the oil
pressure sender unit (Fig. 4). Remove sender unit
from engine block and plug hole in block.
STEERING
PUMP
ENGINE BLOCK
J9119-74
Fig. 4 Oii Pressure Sending Unit
(4) Disconnect and cap the oil feed line from the
bottom of the vacuum pump (Fig. 5).
BATTERY
GROUND
CABLE
STEERING PUMP BRACKET
ATTACHING NUT
J9119-75
Fig. 5 Oii Feed Line Removal/lnstaliation
(5) Remove the lower bolt that attaches the vacu­
um/steering pump assembly to the engine block. Re­
move the nut from the steering pump attaching
bracket (Fig. 5).
(6) Remove upper bolt from the pump assembly
(Fig. 6). Remove the assembly from the engine (Fig.
7).
J9119-76
Fig. 6 Pump Assembly Upper Bolt
(7) Remove the gasket from the mounting surfaces
on engine block and pump assembly.
(8) Drain the fluid from the steering pump.