Dodge RAM TRUCK 1500 1995 Service Manual page 1427

21 - 144 42RH/46RH/47RH TRANSMISSION IN-VEHICLE SERVICE — — — —
B R
ENGINE
BRACKET
CABLE
BRACKET
RETAINER
AND
BUTTON
THROTTLE
VALVE
CABLE CONTROL
LEVER
STUD
J9421-244
Fig. 6 Throttle Valve Cable Attachment At Engine
(V6/V8 Gas Engine)
ACCELERATOR
CABLE
S T U D T.V. CABLE
STUD
THROTTLE
VALVE
CABLE
ENGINE
BRACKET
RETAINER
A N D
BUTTON
J9421-245
Fig. 7 Throttle Valve Cable Attachment At Engine
(WW Engine)
(3) Rotate cable out of transmission bracket (Figs.
10, 11, 12).
(4) Disengage cable from body clips.
(5) Lower vehicle.
(6) Disengage cable at engine bracket and from le­
ver stud on throttle body or fuel injection pump.
(7) Remove cable from engine compartment.
(8) Position new cable in engine compartment.
Connect cable to engine bracket but do not connect
cable to throttle lever stud on throttle body or injec­
tion pump at this time.
(9) Raise vehicle and secure cable in body clips.
(10) Attach cable to transmission throttle valve le­
ver.
(11) Be sure lever return spring is attached (Fig.
13). Transmission will not shift properly if spring is
not connected.
(12) Check and adjust throttle valve cable. Refer to
procedures in this section.
CABLE
BUTTON
THROTTLE
VALVE
CABLE
THROTTLE
BODY
LEVER
ALIGN CABLE
A N D STUD TO
WITHIN 1 M M
(0.039
IN.;
OF CENTER
J9521-54
Fig. 8 Throttle Valve Cable Adjustment Components
(Gas Engine Shown)
THROTTLE
BODY
THROTTLE
VALVE
CABLE
CABLE
END
TRANSMISSION
SHIFT
LEVER J9421-246
Fig. 9 Throttle Valve Cable Control Levers (Gas
Engine Shown)
FRONT BAND ADJUSTMENT
The front (kickdown) band adjusting screw is lo­
cated on the left side of the transmission case above
the manual valve and throttle valve levers.
(1) Raise vehicle.
(2) Loosen front (kickdown) band adjusting screw
locknut (Fig. 14).
(3) Back locknut off 3-5 turns. Be sure adjusting
screw turns freely in case. Apply lubricant to screw
threads if necessary.