Dodge RAM TRUCK 1500 1995 Service Manual page 1608

B R
NV 021 PTO ADAPTER 21 - 327
(b) Apply bead of Mopar Gasket Maker, Loctite
518, or Mopar silicone adhesive sealer to seal sur­
face of retainer. Sealer bead should be no more
than 1/8 to 3/16 in. wide.
CAUTION; if a silicone sealer is used, do not use
any more sealer than recommended. Excessive
amounts of sealer will be displaced into the area
between the retainer and case. This could result in
partial or full blockage of the bearing oil feed hole
in the front case.
(c) Apply transmission fluid to input gear hub.
(d) Align retainer channel with feed hole in case
and install retainer (Fig. 67).
(e) Apply sealer to retainer bolts. Then install
and tighten bolts to 16-24 N-m (12-18 ft. lbs.)
torque.
Fig. 66 Retainer Oii Channel And Case Oil Feed
Hole Locations
(33) Install poppet plunger and spring in front case
detent bore (Fig. 68).
(34) Install new O-ring on poppet plunger screw.
Then install screw in front case (Fig. 69). Tighten
screw to 16-24 N-m (12-18 ft. lbs.) torque.
(35) Install indicator switch in front case. Tighten
switch to 20-34 N-m (15-25 ft. lbs.) torque.
(36) Install and tighten drain plug to 41-54 N-m
(30-40 ft. lbs.) torque.
(37) Fill adapter with 2.1 liters (4.6 pints) liters of
Mopar Dexron II, or ATF Plus transmission fluid and
install fill plug. Tighten fill plug to 41-54 N-m (30-40
ft. lbs.) torque.
Fig. 67 input Bearing Retainer installation
Fig. 68 Poppet Plunger And Spring Installation
Fig. 69 Poppet Plunger Screw Installation
(38) Apply Mopar silicone adhesive/sealer to PTO
cover mating surface and to threads of cover bolts.
Then install cover and tighten bolts to 27-34 N-m
(20-25 ft. lbs.) torque.