Dodge RAM TRUCK 1500 1995 Service Manual page 1240

B R DIFFERENTIAL ANU
U K I V C L H U .
D I S A S S E M B L Y A N D A S S E M B L Y { C o n t i n u e d )
(4) Press the bearing assembly partially from the
outboard side of the center yoke, enough to grasp by
vise jaws (Fig. 23). Be sure to remove grease fittings
that interfere with removal.
J9316-6
Fig. 23 Press Out Bearing
(5) Grasp the protruding bearing by vise jaws. Tap
the tube yoke with a mallet and drift to dislodge
from the yoke (Fig. 24).
(6) Flip assembly and repeat steps 4 and 5 for
removing the opposite side bearing. This will then
allow removal of the cross centering kit assembly and
spring (Fig. 25).
J9316-8
Fig. 25 Remove Centering Kit
(7) Press the remaining bearing assemblies out the
other cross as described above to complete the disas­
sembly.
INSTALLATION
During installation, ensure that the spiders
and yokes are aligned to the reference marks.
(1) Fit a cross into the tube yoke (Fig. 26).
J9316-7
Fig. 24 Remove Bearing From Yoke
J9316-9
Fig. 26 install Cross In Yoke