Dodge RAM TRUCK 1500 1995 Service Manual page 1155

B R — — — — COMPONENT REMOVAL/INSTALLATION—EXCEPT DIESEL 14 - 73
MULTI-PORT FUEL INJECTION fl«FI!—COMPONENT REMOVAL/INSTALLATION
E X C E P T DIESEL
INDEX
page
Accelerator Pedal and T irottle Cable 75
Air Cleaner Housing/Air Cleaner Element (Filter) . . 73
Air Conditioning (A/C) Clutch Relay . . . . . . . . . . . . 75
Automatic Shutdown (ASD) Relay . 75
Brake Switch 75
Camshaft Position Sensor 75
Crankshaft Position Sensor 75
Engine Coolant Temperature Sensor . . . . . . . . . . . 76
EVAP Canister Purge Solenoid 76
Fuel Filter 76
Fuel Injector(s) 76
Fuel Pressure Regulator 76
Fuel Pump 77
Fuel Pump Module . . 77
Fuel Pump Relay 77
Fuel Rail 77
Fuel System Pressure Release Procedure . . . . . . . 80
AIR CLEANER HOUSING/AIR CLEANER ELEMENT
(FILTER)
3.9L/5.2L/5.9L GAS ENGINES
For air cleaner element required maintenance
schedules (listed in time or mileage intervals), refer
to Group 0, Lubrication and Maintenance.
iElOWAL/IlSIALLATlil
CAUTION: Do not attempt to remove the air cleaner
element from the housing by removing the top
cower only. To prevent damage to the air cleaner
housing, the entire air cleaner housing assembly
must be removed from the engine for air cleaner el­
ement replacement.
(1) Remove the air inlet tube (Fig. 1) at the side of
the air cleaner housing.
(2) A band-type screw clamp secures the air
cleaner housing to the throttle body. Loosen, but do
not remove, this screw clamp (Fig. 1). Note the clamp
positioning tabs on the air cleaner housing.
(3) All Gas Powered Engines: Disconnect the
breather hose at the rear of air cleaner housing.
5.9L V-8 HDC Engine Only: Disconnect the air
pump hose at the air cleaner housing.
(4) The bottom/front of the air cleaner housing is
equipped with a rubber grommet (Fig. 1). A mounting
stud is attached to the intake manifold (Fig. 1) and is
used to position the air cleaner housing into this
grommet. Lift the assembly from the throttle body
while slipping the assembly from the mounting stud
(Fig. 1).
page
Fuel Tank Pressure Relief/Rollover Valve . 80
Fuel Tanks . 80
Fuel Tubes/Lines/Hoses and Clamps 80
Idle Air Control (IAC) Motor 80
Ignition Coil 80
Intake Manifold . 81
Intake Manifold Air Temperature Sensor . 75
Manifold Absolute Pressure (MAP) Sensor 81
Oxygen (02S) Sensor 82
Park/Neutral Switch 83
Powertrain Control Module (PCM) . 83
Quick-Connect Fittings 83
Throttle Body 83
Throttle Position Sensor (TPS) 84
Transmission Temperature Sensor 85
Vehicle Speed Sensor 86
AIR INLET
Fig. 1 Air Cleaner Housing—3.9U5.2U5.9L Gas
Powered Engines—Typical
(5) Check condition of gasket at throttle body and
replace as necessary.