Dodge RAM TRUCK 1500 1995 Service Manual page 1481

21 - 200 42RH TRANSMISSION OVERHAUL
Fig. 149 Aligning Rear Clutch Disc Lugs
mediate shaft thrust w a s h e r and thrust plate
are not displaced during installation.
(26) Carefully work assembled clutches back and
forth to engage and seat rear clutch discs on front an­
nulus gear. Also be sure front clutch drive lugs are fully
engaged in slots of driving shell after installation.
(27) Slide front band over front clutch retainer
(Fig. 151).
(28) Insert front band reaction pin part way into
case (Fig. 151).
(29) Install front band lever, strut and adjusting
screw (Fig. 152).
(30) Push front band reaction pin completely into
place. Then tighten band adjusting screw until band
just grips clutch retainer. Verify that front/rear
clutches are still seated before continuing.
e n
J9121-124
Fig. 150 Front/Rear Clutch Assembly Installation
Fig. 151 Front Band And Reaction Pin Installation
(31) Coat band reaction pin access plug with sealer
and install plug in converter housing.
(32) Check seal rings on reaction shaft support
hub. Verify that seal rings are hooked together and
that front clutch thrust washer is properly positioned
(Fig. 153). Thrust washer I.D. is chamfered on
one side. Install chamfered side to front.
(33) Thread two Pilot Stud Tools C-3288-B into
bolt holes in oil pump flange (Fig. 154).
(34) Align and install oil pump gasket (Fig. 154).
(35) Lubricate oil pump body seal with Ru-Glyde,
or petroleum jelly. Lubricate pump shaft seal lip with
petroleum jelly.
(36) Install oil pump (Fig. 155). Align and position
pump on pilot studs. Slide pump down studs and