Dodge RAM TRUCK 1500 1995 Service Manual page 1637

23 -12 BODY COMPONENTS
BR
FENDER DOOR CAB
MOLDING MOLDING MOLDING J9523-127
Fig. 10 Stick-on Body Side Moldings—Club Cab
(2) Pull stick-on molding from painted surface.
(3) Remove adhesive tape residue from painted
surface of vehicle.
(4) If molding is to be reused, remove tape residue
from molding. Clean back of molding with MOPAR,
Super Kleen solvent or equivalent. Wipe molding dry
with lint free cloth. Apply new body side molding
(two sided adhesive) tape to back of molding.
(5) Clean body surface with Super Kleen solvent or
equivalent. Wipe surface dry with lint free cloth.
(6) Apply a length of masking tape on the body,
parallel to the top edge of the molding to use as a
guide, if necessary.
(7) Remove protective cover from tape on back of
molding. Apply molding to body below the masking
tape guide.
(8) Remove masking tape guide and heat body and
molding, see step one. Firmly press molding to body
surface to assure adhesion.
BODY EMBLEMS
REMOVAL (FIG. 11 AND 12)
(1) Insert a plastic trim stick or a hard wood
wedge behind the emblem to separate the adhesive
backing from the body.
(2) Clean adhesive residue from body with MOPAR
Super Clean solvent or equivalent.
INSTALLATION
When a new emblem is being installed, steps 1, 2
and 3 installation procedure are not required.
(1) If The original emblem is to be reused, peel old
adhesive tape from back of emblem.
(2) Clean adhesive residue from emblem with Mo­
par Super Clean solvent or equivalent.
Fig. 11 Body Emblems and Tailgate Decals
J9423-182