Dodge RAM TRUCK 1500 1995 Service Manual page 1646

J R
DOORS 23 - 21
Fig. 10 Door Glass Run Weatherstrip
INSTALLATION
Reverse the preceding operation.
DOOR GLASS
REMOVAL
(1) Remove door trim panel.
(2) Remove weather shield as necessary to gain ac­
cess to door glass lift plate.
(3) Remove inner door belt weatherstrip.
(4) Align door glass lift plate to access holes in in­
ner door panel.
(5) Loosen bolts holding front lower run channel to
inner door panel.
(6) Remove nuts holding door glass to lift plate
(Fig.
11).
Fig. 11 Door Glass
(7) Separate glass from lift plate.
(8) Lift glass upward and out of opening at top of
door.
INSTALLATION
Reverse the preceding operation.
DOOR GLASS WIDOW REGULATOR
REMOVAL (PIG. 12)
DOOR ASSEMBLY
WINDOW DOOR GLASS
REGULATOR ASSEMBLY
J9423-38
Fig. 12 Door Glass Window Regulator
(1) Remove door trim panel.
(2) Remove water dam.
(3) Remove nuts holding door glass to window reg­
ulator.
(4) Remove glass from door or move glass to full up
position.
(5) Disengage power window motor wire connector
from door harness, if equipped.
(6) Remove bolts holding window regulator to in­
ner door panel.
(7) Separate window regulator from door panel.
(8) Extract window regulator through access hole
in inner door panel.
INSTALLATION
Reverse the preceding operation.
DOOR GLASS RUi LOWER CHANNELS
REMOVAL
(1) Remove door trim panel and weather shield.
(2) Roll door glass up.
(3) Remove bolts holding run channel to inner door
panel (Fig. 13).
(4) Slide channel downward to disengage it from
the upper glass frame.
(5) Separate door glass run channel from door.
INSTALLATION
Reverse the preceding operation.