21 - 168
42RH TRANSMISSION OVERHAUL
~
- ^ - ^
B R
OIL SEAL
REACTION SHAFT
SUPPORT
GASKET
O-RING
SEAL
PUMP HOUSING
THRUST
WASHER
Fig. 40 Oii Pump And Reaction
pumps has a n e w design d r i v e lug. The n e w de
sign incorporates drive flats instead of the
square l u g used previously; The
t o r q u e con
verter hub has also been redesigned to accept
the new drive. If pump gear replacement is nec
essary, be very sure to order and install the
new style gears.
Inspect the pump and reaction shaft support bush
ings. Minor bushing wear is acceptable. Replace the
bushings only if scored, or severely worn.
Install the gears in the pump housing and measure
end clearance with a feeler gauge and straightedge
(Fig. 41). Clearance should be 0.010 - 0.06 mm
(0.0004 - 0.0025 in.).
STRAIGHT EDGE
fij'j!
J9321-215
Fig. 41 Measuring Pump Gear End Clearance
J 9 4 2 M 5 1
Shaft Support
Components
Measure clearance between the outer gear and the
pump body (Fig. 42). Clearance should be 0.08 - 0.19
mm (0.0035 -
0.0075
in.).
Measure gear tooth clearance with a feeler gauge.
Align one tooth of the outer gear in inner gear and
measure clearance (Fig. 43). Clearance should be
0.08 - 0.19 mm (0.0035 - 0.0075 in.).
FEELER
GAUGE
INNER
GEAR
J9321-216
Fig. 42 Measuring Pump Housing-To-Inner
Gear
Clearances
REPLACING
&il
PPJMP
BUSHENQ
(1) Remove pump bushing with Tool Handle
C-4171 and Bushing Remover SP-3551 (Fig. 44).
(2) Install new pump bushing with Tool Handle
C-4171 and Bushing Installer SP-5117 (Fig. 44).
Bushing should be flush with pump housing bore.