IGNITION SYSTEMS
8 D - 1
CONTENTS
page
page
COMPONENT IDENTIFICATION/SYSTEM
DIAGNOSTICS/SERVICE PROCEDURES
I
OPERATION
1
33
COMPONENT REMOVAL/INSTALLATION
22
36
COMPONENT IDENTIFICATION/SYSTEM OPERATION
INDEX
page
2
2
Camshaft Position Sensor-8.OL V-10 Engine
3
3
Crankshaft Position Sensor-8.0L V-10 Engine
. . . . 4
5
Engine Coolant Temperature Sensor
7
GENERAL INFORMATION
Throughout this group, references are made to par
ticular vehicle models by alphabetical designation or
by the particular vehicle nameplate. A chart showing
a breakdown of alphabetical designations is included
in the Introduction group at the beginning of this
manual.
All vehicles are equipped with either a 3.9L V-6 en
gine, a 5.2L V-8 engine, two different 5.9L V-8 en
gines, an 8.0L V-10 engine or a 5.9L Cummins in-line
6-cylinder diesel engine. Refer to Group 14, Fuel Sys
tem for diesel fuel service procedures.
The 3.9L V-6 and 5.2L V-8 engines will be referred
to in this Ignition group as: Light Duty Cycle (LDC)
engines. The 5.9L V-8 gas powered engine will be re
ferred to as either: Light Duty Cycle (LDC) or Heavy
Duty Cycle (HDC) engine. The 8.0L V-10 engine will
be referred to as: Heavy Duty Cycle (HDC) engine.
Either of the HDC gas powered engines can be eas
ily identified by the use of an engine mounted air in
jection pump. The 3.9L V-6 engine, the 5.2/5.9L V-8
LDC gas engines or the diesel engine will not use an
air injection pump.
This section of the group, Component Identifica
tion/System Operation, will discuss ignition system
operation and will identify ignition system compo
nents.
page
1
Ignition Coil Packs-8.0L V-10 Engine
6
. . . . 5
Ignition Control Module-8.0L V-10 Engine
7
Intake Manifold Air Temperature Sensor
7
Manifold Absolute Pressure (MAP) Sensor
7
Oxygen Sensor (02S)
8
Powertrain Control Module (PCM)
7
For diagnostic procedures and adjustments, refer to
the Diagnostics/Service Procedures section of this
group.
For removal and installation of ignition system
components, refer to the Component Removal/Instal
lation section of this group.
For other useful information, refer to On-Board Di
agnostics in the General Diagnosis sections of Group
14, Fuel System in this manual.
For operation of the DRB Scan Tool, refer to the
appropriate Powertrain Diagnostic Procedures ser
vice manual.
An Ignition specifications section is included at the
end of this group. A general Maintenance Schedule
(mileage or time intervals) for ignition related items
can be found in Group 0, Lubrication and Mainte
nance. This schedule can also be found in the Owners
Manual.
IGNITION
SYSTEMS
The ignition systems used on the 3.9L V-6, 5.2L V-8
and both of the 5.9L V-8 engines are basically iden
tical with each engine using a mechanical distributor.
Similarities and differences between the systems will
be discussed.