Dodge RAM TRUCK 1500 1995 Service Manual page 1661

23 - 31 INTERIOR COMPONENTS
QUARTER TRIM PANEL
REMOVAL
(1) Remove rear floor stowage tray.
(2) Remove door sill cover as necessary to clear
quarter trim.
(3) Remove bolt holding seat belt anchor to floor.
(4) Remove push-in fasteners holding quarter trim
panel to lower quarter panel (Fig. 4).
RETAINING SEAT BELT
PUSH-IN
FASTENER J9523-149
Fig. 4 Quarter Trim Panel
(5) Disengage clips holding quarter trim panel to
upper quarter panel.
(6) Separate quarter trim panel from quarter
panel.
(7) Pull seat belt webbing through opening in quar­
ter trim panel.
INSTALLATION
Reverse the preceding operation.
QUARTER TRIM PANEL—CLU1 CA1
(1) Remove rear seat. Refer to the removal proce­
dure in this section, if necessary.
(2) Remove door sill cover as necessary to clear
quarter trim.
(3) Using a trim stick or small flat blade screw­
driver, remove cup holder (Fig. 5).
(4) Remove lower seat belt anchor bolts (Fig. 6).
(5) Remove screws holding club cab quarter trim
panel to quarter panel (Fig. 6).
(6) Separate club cab quarter trim panel from
quarter panel.
(7) Pull seat belt webbing through opening in quar­
ter trim panel and remove panel from vehicle.
BOLT BOLT J9523-138
Fig. 5 Cup Holder Removal
Fig. 6 Quarter Trim Panel—Club Cab
INSTALLATION
(1) Position trim panel in vehicle and pull seat belt
webbing through opening in quarter trim panel.
(2) Position trim panel at quarter panel and install
trim panel screws.
(3) Install lower seat belt anchor bolts.
(4) Install cup holder.
(5) Install door sill cover as necessary.
(6) Install rear seat. Refer to the installation pro­
cedure in this section, if necessary.
REAR CLOSURE PANEL TRIM
REMOVAL (FIG* 7}
(1) Remove quarter trim panels.
(2) Remove rear floor stowage tray.
(3) Remove stowage bins.
(4) Remove stowage net.
(5) Remove screws holding bottom of rear closure
panel trim to floor.
(6) Remove screws holding rear closure panel trim
to rear cab wall.