•
14 - 86
COMPONENT REMOVAL/INSTALLATION—EXCEPT DIESEL
BR
VEHICLE SPEED SENSOR
The vehicle speed sensor (Pig. 38) is located on the
extension housing of the transmission on 2WD mod
els. It is located on the transfer case on 4WD models.
REMOVAL
SENSOR
ELECTRICAL
CONNECTOR
TRANSMISSION
EXTENSION
HOUSING
SPEEDOMETER
PINION GEAR
ELECTRICAL
CONNECTOR
O-RING
SENSOR
MOUNTING
BOLT
SPEEDOMETER PINION
GEAR ADAPTER
VEHICLE
SPEED
SENSOR
O-RING
J9314-188
Fig. 39 Sensor
Removal/Installation—Typical
J9414-60
Fig. 38 Vehicle Speed Sensor
Location—Typical
(1) Raise and support vehicle.
(2) Clean the area around the sensor before re
moval.
(3) Disconnect the electrical connector from the
sensor (Fig. 39).
(4) Remove the sensor mounting bolt (Fig. 39).
(5) Pull the sensor from the speedometer pinion
gear adapter for removal. ^
INSTALLATION
(1) Install new sensor into speedometer gear
adapter.
(2) Tighten sensor mounting bolt. To prevent dam
age to sensor or speedometer adapter, be sure the
sensor is mounted flush to the adapter before tight
ening.
(3) Connect electrical connector to sensor.