Dodge RAM TRUCK 1500 1995 Service Manual page 1478

BR
42RH TRANSMISSION OVERHAUL 21 -197
stalled. Bolt holes in cam are slightly counter­
sunk on one side. Be sure this side of cam faces
rearward (toward piston retainer).
Fig. 135 Overrunning Clutch Installation
(7) Verify that non-threaded hole in clutch cam is
properly aligned. Check alignment by threading a
bolt into each bolt hole. Adjust clutch cam position if
necessary.
(8) Install and tighten overrunning clutch cam
bolts to 17 N-m (13 ft. lbs.) torque. Note that clutch
cam bolts are shorter than piston retainer bolts.
(9) Lubricate clutch cam rollers with transmission
fluid.
(10) Install rear band reaction pin (Fig. 136). Be
sure pin is fully seated in case.
Fig. 136 Rear Band Reaction Pin Installation
(11) Install rear band in case (Fig. 137). Be sure
twin lugs on band are seated against reaction pin.
(12) Install low-reverse drum and check overrun­
ning clutch operation as follows:
(a) Lubricate overrunning clutch race (on drum
hub) with transmission fluid.
(b) Guide drum through rear band.
Fig. 137 Rear Band Installation
(c) Tilt drum slightly and start race (on drum
hub) into overrunning clutch rollers.
(d) Press drum rearward and turn it in clockwise
direction until drum seats in overrunning clutch
(Fig. 138).
(e) Turn drum back and forth. Drum should ro­
tate freely in clockwise direction and lock in
counterclockwise direction (as viewed from
front of case).
Fig. 138 Low-Reverse Drum Installation
(13) Install new gasket at rear of transmission case.
Use petroleum jelly to hold gasket in place. Be sure to
align governor feed holes in gasket with feed passages
in case (Fig. 139). Also install gasket before overdrive
piston retainer. Center hole in gasket is smaller than
retainer and cannot be installed over retainer.