Dodge RAM TRUCK 1500 1995 Service Manual page 1535

21 - 254 46RH/47RH TRANSMISSION OVERHAUL
J932M33
Fig. 172 Checking Alignment Of Overdrive Planetary
Gear And Overrunning Clutch Splines
173). Position indicator plunger against input shaft
and zero indicator.
(3) Move input shaft in and out and record read­
ing.
(4) End play should be 0.86 - 2.13 mm (0.034 -
0.084 in.).
(5) If end play is incorrect, change intermediate
shaft thrust washer. The thrust washer controls end
play and is available in three thicknesses for adjust­
ment purposes.
Fig. 173 Checking Input Shaft End Play
BAND ADJUSTMENTS AND INSTALLATION OF
ACCUMULATOR, VALVE BODY, OIL PAN, AND
TORQUE CONVERTER
(1) On 46RH, install accumulator inner spring, pis­
ton and outer spring (Fig. 174). On 47RH, install
accumulator piston and single spring.
(2) Verify that park/neutral position switch has
not been installed in case. Valve body can not be in­
stalled if switch is in position.
(3) Install valve body as follows:
(a) Start park rod into park pawl. If rod will not
slide past park pawl, pawl is engaged in park gear.
Fig. 174 Accumulator Piston And Spring Installation
(46RH Shown)
Rotate overdrive output shaft with socket to free
pawl and allow rod to engage.
(b) Align and seat valve body on case. Be sure
manual lever shaft and overdrive connector are
fully seated in case.
(c) Install and start all valve body attaching
bolts by hand. Then tighten bolts evenly, in a diag­
onal pattern to 12 N-m (105 in. lbs.) torque. Do not
overtighten valve body bolts. This could re­
sult in distortion and cross leakage after in­
stallation..
(4) Install new filter on valve body. Tighten filter
screws to 4 N-m (35 in. lbs.).
(5) Install seal on park/neutral position switch
(Fig. 175). Then install and tighten switch to 34 N-m
(25 ft. lbs.).
Fig. 175 Park/Neutral Position Switch Seal Position
(6) Adjust front and rear bands as follows:
(a) Loosen band adjusting screw locknuts 4-5
turns. Then tighten adjusting screws to 8 N-m (72
in. lbs.).
(b) Back off front band adjusting screw 2-7/8
turns on 46RH and 1-7/8 turns on 47RH.
(c) Back off rear band adjusting screw 2 turns on
46RH and 3 turns on 47RH.
(d) Hold each adjusting screw in position and
tighten each locknut to 34 N-m (25 ft. lbs.) torque.
(7) Install magnet in oil pan. Magnet goes on small
protrusion at corner of pan.
(8) Position new oil pan gasket on case and install
oil pan. Tighten pan bolts to 17 N-m (13 ft. lbs.).