Dodge RAM TRUCK 1500 1995 Service Manual page 1606

B i t
I f 021 PTO ADAPTER 21 - 325
SPEEDOMETER
GEAR
(SEAT ON
RETAINING
RING)
J9421-429
Fig. 56 Speedometer Gear instaiiation
SPEEDOMETER
GEAR REAR
RETAINING
RING
J9421-430
Fig. 57 Speedometer Front Ring instaiiation
ward r e a r of shaft. If bearing is reversed, re­
taining ring (in extension) will not align
bearing.
Fig. 58 Output Bearing instaiiation
(23) Install output bearing retaining ring (Fig. 59).
Use parallel jaw pliers to install ring.
Fig. 59 Output Bearing Retaining Ring instaiiation
(24) Install new seal in rear extension if necessary.
Use suitable size installer tool and be sure seal is
fully seated.
(25) Apply bead of Mopar Gasket Maker, Loctite
518, or Mopar silicone adhesive sealer to mating sur­
face of front case and rear extension. Sealer beads
should be no more than 1/8 to. 3/16 in. wide.
(26) Align and install rear extension on front case
(Fig. 60).
Fig. 60 Installing Rear Extension On Front Case
(27) Install one or two extension-to-front case bolts
to hold assembly together. Be sure dowels are aligned
in extension before hand tightening bolts.
(28) Remove adapter assembly from wood blocks
and place assembly in horizontal position on work­
bench.