Dodge RAM TRUCK 1500 1995 Service Manual page 1156

14 - 7 4 COMPONENT REMOVAL/INSTALLATION—EXCEPT DIESEL
BR
(6) The housing cover is equipped with three (3)
spring clips (Fig. 1) and is hinged at the rear with
plastic tabs. Unlatch the clips from the top of air
cleaner housing and tilt the housing cover up and
rearward for cover removal.
(7) Remove the air cleaner element from air
cleaner housing.
(8) Before installing a new air cleaner element,
clean inside of air cleaner housing.
(9) Position air cleaner cover to tabs on rear of air
cleaner housing. Latch the three spring clips to seal
cover to housing.
(10) Position the air cleaner housing assembly to
the throttle body while guiding the rubber grommet
over the mounting stud. The lower part of the screw
clamp should be below the top lip of the throttle
body.
(11) Push down on air cleaner housing at rubber
grommet to seat housing at intake manifold.
(12) Tighten throttle body-to-air cleaner housing
clamp to 4 N-m (35 in. lbs.) torque.
(13) Install the air inlet tube at air cleaner hous­
ing inlet.
8 . 0 L V - 1 0 ENGINE
For air cleaner element required maintenance
schedules (listed in time or mileage intervals), refer
to Group 0, Lubrication and Maintenance.
A small amount of engine oil wetting the inside of
the air cleaner housing is normal. When servicing,
wipe out the oil from the air cleaner housing.
iElOfAL/INSIALLATiON
(1) Loosen the clamp (Fig. 2) and remove the air
inlet tube (Fig. 3) at the front of the air cleaner hous­
ing cover.
C L A M P A D J U S T A B L E P L I E R S
J9314-136
Fig. 2 Clamp Removal
(2) The air cleaner housing and air cleaner ele­
ment cover are equipped with spring clips to seal the
HOUSING
Fig. 3 Air Cleaner Housing—8.0L V-10 Engine—
Typical
cover to housing (Fig. 3). Unlatch the clips from the
air cleaner cover and remove cover from air cleaner
housing.
(3) Remove the air cleaner element from air
cleaner cover.
(4) Before installing a new air cleaner element,
clean inside of air cleaner housing.
(5) Position air cleaner element into air cleaner
cover. Latch the spring clips to seal cover to housing.
(6) Install the air inlet tube at air cleaner housing
inlet.
(7) Install and tighten clamp at air inlet tube (Fig.
4).
C L A M P A D J U S T A B L E P L I E R S
Fig. 4 Clamp Installation