Dodge RAM TRUCK 1500 1995 Service Manual page 1466

B R
42RH TRANSMISSION OVERHAUL 21-183
(6) Remove retaining tool and remove detent ball
and spring (Fig. 94).
M A N U A L
L E V E R
M A N U A L
LEVER
DETENT
H O U S I N G
D E T E N T
B A L L „
A N D
S P R I N G
J 9 3 2 M 3 9
Fig. 94 Detent Bail And Spring Removal
(7) Remove washer at top of manual lever shaft.
Then lift manual lever and park rod assembly up­
ward and out of valve body (Fig. 95).
M A N U A L
L E V E R
A N D
P A R K
R O D
A S S E M B L Y
MANUAL
LEVER
WASHER
J9321-140
Fig. 95 Manual Lever Removal
(8) Remove throttle lever from valve body housing
(Fig. 96).
T H R O T T L E
L E V E R
J 9 3 2 M 4 1
Fig. 96 Throttle Lever Removal
(9) Remove park rod E-clip and separate rod from
manual lever (Fig. 97).
P A R K
R O D
J9121-81
Fig. 97 Park Rod Removal
(10) Remove screws attaching pressure adjusting
screw bracket to valve body and transfer plate. Hold
bracket firmly against spring tension while removing
last screw.
(11) Remove adjusting screw bracket, line pressure
adjusting screw, pressure regulator spring and switch
valve spring (Fig. 98). Do not remove throttle
pressure adjusting screw from bracket and do
not disturb adjusting screw settings during re­
moval.
P R E S S U R E
R E G U L A T O R
V A L V E S P R I N G
S W I T C H
V A L V E
S P R I N G
L I N E P R E S S U R E
A D J U S T I N G S C R E W
A D J U S T I N G
S C R E W
B R A C K E T
J9121-512
Fig. 98 Adjusting Screw Bracket And Spring
Removal
(12) Remove solenoid connector from 3-4 accumula­
tor housing (Fig. 99). Note that connector is at­
tached to housing with shoulder-type screw.
Keep this screw with accumulator housing to
avoid losing it.
(13) Note routing of solenoid wires for assembly
reference (Fig. 100).
(14) Remove screws attaching solenoid assembly to
valve body lower housing and remove solenoid and
connector assembly (Fig. 101).