Dodge RAM TRUCK 1500 1995 Service Manual page 1663

23 - 38 INTERIOR COiPONENTS
INSTALLATION
Reverse the preceding operation. Install the seat
belt buckle anchor nuts. Tighten to 40 N-m (30 ft.
lbs.) torque.
REAR SEAT BELT BUCKLE
REMOVAL
(1) Turn release handle on underside of rear seat
to disengage seat cushion and move seat to the
stowed position.
Access to rear seat belt buckle nuts can be obtained
through an opening between the rear seat back and
the floor.
(2) Remove seat belt buckle anchor nuts (Fig. 3).
Fig. 3 Rear Seat Belt Buckle Removal
(3) Separate seat belt buckle from vehicle.
INSTALLATION
(1) Position the seat belt buckle on the anchoring
studs.
(2) Install the seat belt buckle anchor nuts.
Tighten to 40 N-m (30 ft. lbs.) torque.
(3) Turn release handle to disengage seat from
stowed position and push seat cushion downward to
lock into place.
HEADLINER
REMOVAL (FIG. 4)
(1) Remove sun visors and visor hooks.
(2) Remove overhead assist handle.
(3) Remove coat hook.
(4) Remove overhead console, if equipped. Refer to
Group 8C, Overhead Console for removal procedure.
(5) Remove A-pillar moldings.
(6) Remove quarter trim panels.
(7) Remove dome lamp. Refer to Group 8L, Lamps
for removal procedure.
(8) Separate headliner from roof panel.
(9) Extract headliner through door opening.
HEADLINER
Fig. 4 Headliner
INSTALLATION
Reverse the preceding operation.
OVERHEAD ASSIST HANDLE
REMOVAL
(1) Disengage tabs holding assist handle end cov­
ers to assist handle.
(2) Remove screws holding overhead assist handle
to roof rail (Fig. 5).
Fig. 5 Overhead Assist Handle
(3) Separate overhead assist handle from vehicle.
INSTALLATION
Reverse the preceding operation.