Dodge RAM TRUCK 1500 1995 Service Manual page 1693

24 - 24 HEATING AND AIR CONDITIONING
B R
RECIRCULATING AIR POOR
REMOVAL
(1) Remove the heater-A/C housing from the vehi­
cle (refer to Heater-A/C Housing Removal).
(2) Disconnect the actuating rod clip (Fig. 13).
(3) Pry the recirculating door shaft retainer from
the shaft (Fig. 13).
(4) Remove the recirculating door through the top
opening.
INSTALLATION
(1) Install the recirculating door through the top
opening and position in place.
(2) Press the recirculating door shaft retainer onto
the shaft.
(3) Connect the rod and rod clip to the door lever.
(4) Install the heater-A/C housing into the vehicle
(refer to Heater-A/C Housing Installation).
TEMPERATURE / BLEND AIR DOOR CABLE
The temperature cable is located under the instru­
ment panel and can be removed from the passenger
compartment.
REMOVAL
(1) Remove steering column and roll instrument
panel down (refer to Group 8E, Instrument Panel
and Gauges).
(2) Disconnect the cable from the top of the hous­
ing (Fig. 14).
(3) Disconnect the cable from the heater A/C con­
trol (Fig. 15).
INSTALLATION
(1) Connect the cable to the heater-A/C control.
(2) Connect the cable to the top of the heater-A/C
housing.
(3) Install the instrument panel and steering col­
umn (refer to Group 8E, Instrument Panel and Gaug­
es).
TEMPERATURE / BLEND AIR DOOR
REMOVAL
(1) Remove the heater-A/C housing from the vehi­
cle (refer to Heater-A/C Housing Removal).
(2) Turn the heater-A/C housing upside down.
(3) Remove the retaining screws holding the two
halves together. Remove the center adaptor heat duct
and remove the screw.
(4) Remove the bottom half of the heater-A/C hous­
ing.
(5) Remove the door (Fig. 16).
INSTALLATION-
(1) Install the door.
LOCKING
TAB
J948E-65
Fig. 14 Temperature/Blend Air Door Cable (Heater-A/
C Housing)
VACUUM
LINES
TEMPERATURE/
BLEND A I R
DOOR CABLE
J9424-7
Fig. 15 Temperature/Blend Air Door Cable
(2) Position the top half of the heater-A/C housing
onto the bottom. Be sure the door pivot pins align
with the pivot holes.
(3) Carefully turn the heater-A/C housing over. In-