Dodge RAM TRUCK 1500 1995 Service Manual page 1533

21 - 212 46RH/47RH TRANSMISSION OVERHAUL
(2) Install new oil pump gasket on pilot studs and
seat it in case. Be sure gasket is properly aligned
with fluid passages in case (Fig. 165).
Fig. 165 Oil Pump Gasket And Pilot Stud Installation
(3) Coat front clutch thrust washer with petroleum
jelly to hold it in place. Then install washer over re­
action shaft hub and seat it on pump (Fig. 166).
CAUTION: The thrust washer bore (I.D.), is cham­
fered on one side. Make sure the chamfered side is
installed so it faces the pump.
Fig. 166 Front Clutch Thrust Washer Installation
(4) Check seal rings on reaction shaft support. Be
sure rings are hooked together correctly. Also be sure
fiber thrust washer is in position (Fig. 167). Use ex­
tra petroleum jelly to hold washer in place if neces­
sary.
(5) Lubricate oil pump seals with petroleum Mopar
ATF Plus.
(6) Mount oil pump on pilot studs and slide pump
into case opening (Fig. 168). Work pump into case
by hand. Do not use a mallet or similar tools to
seat pump.
mm
Fig. 167 Reaction Shaft Seal Ring And Thrust
Washer Installation
(7) Remove pilot studs and install oil pump bolts.
Tighten pump bolts alternately and evenly to fully
seat pump in case. Then final-tighten pump bolts to
20 N-m (15 ft. lbs.) torque.
Fig. 168 Oil Pump Installation
(8) Verify correct installation. Rotate input and in­
termediate shafts and check for bind. If bind exists,
components are either misassembled, or not seated.
Disassemble and correct as necessary before proceed­
ing.