Dodge RAM TRUCK 1500 1995 Service Manual page 1611

21 - 330 NV 021 PTO ADAPTER —
B R
Overdrive Clutch Fourth Gear Only
Pressure should be 469-496 kPa (68-72 psi) with closed throttle and increase to
620-896 kPa (90-130 psi) at 1/2 to 3/4 throttle.
Line Pressure
(at accumulator)
Closed Throttle
1000 rpm and above
372-414 kPa (54-60 psi)
648
kPa
(94
psi)
Front Servo Third Gear Only
No more than 21 kPa (3 psi) lower than line pressure.
Rear Servo
1 Range
R Range
No more then 21 kPa (3 psi) lower than line pressure. 1103 kPa (160 psi) at idle,
builds to 1862 kPa (270 psi) at 1600 rpm.
Governor
D Range
Closed Throttle
Pressure should respond smoothly to changes in mph and return to 0-7 kPa (O-IV2
psi) when stopped with transmission in D, 1, 2. Pressure above 7 kPa (1 %
psi) a t standstill w i l l prevent transmission f r o m downshifting.
J 9 3 2 M 9 2
AUTOMATIC TRANSMISSION TORQUE SPECIFICATIONS
Description Torque
Description
Torque
Cooler Line Fittings (In Case) 18 N»m (13 ft. lbs.
Converter Bolts:
46RH Converter 31 N*m (270 in. lbs.
47RH C o n v e r t e r . . . . . . . . . . . . . . . .47N # m (35 ft. lbs.
Crossmember Bolts/Nuts 68 N»m (50 ft. lbs.
Driveplate Bolts:
46RH . . . . . . . . . . . . . . . . . . . . . .75 N»m (55 ft. lbs.
47RH 102 N»m (75 ft.lbs.
Front Band Reaction Pin Access Plug
Front Band Adjusting Screw Locknut
. 1 7 N T n (13 ft. lbs
.34 N*m (25 ft. lbs
Oil Filter Screws 4 N»m (35 in. lbs,
Oil Pan Bolt 1 7 N * m (13 ft. lbs,
Oil Pump Bolt 20 N«m (15 ft. lbs,
Overrunning Clutch Cam Bolts 17 N*m (150 in. lbs
Overdrive Attaching Bolts 34 N*m (25 ft. lbs
Overdrive Piston Retainer Bolts . . . .17 N«m (150 in. lbs
Park/Neutral Position Switch
. .34 N«m (25 ft. lbs.
Pressure Test Port Plugs
. .14 N*m (10 ft. lbs.
Propeller Shaft Clamp Bolts
.19 N*m (1 70 in. lbs.
Reaction Shaft Support Bolts
. .20 N»m (15 ft. lbs.
Rear Band Adjusting Screw Locknut . . .41 N^m (30 ft. lbs.
Rear Mount Bolts/Nuts
. .68 N»m (50 ft. lbs.
Solenoid Wiring Connector Screw . . . 1 7 N * m (13 ft. lbs.
Speedometer Adapter Bolt
. . .11 N*m (8 ft. lbs.
Transmission-to-
Engine Bolts 41 N«m (30 ft. lbs.]
Valve Body Screws 4 N®m (35 in. lbs.]
Valve Body-to-Case Screws .12 N«m (100 in. lbs.]
J9521-203
AUTOMATIC TRANSMISSION PRESSURE TEST SPECIFICATIONS