Dodge RAM TRUCK 1500 1995 Service Manual page 1555

21 - 274 42RH/46RH/47BH OVERDRIVE OMIT OVI
Fig. 66 Installing Governor Weight Assembly
Fig. 67 Governor Weight Retainer Washer And Snap
Ring Installation
CAUTION; B e very sure the E-clips are fully seated
in the shaft grooves and that the rounded sides of
the clips are facing outward. Otherwise, the clips
will pop off the shaft causing a governor failure.
(8) Install governor assembly snap ring (Fig. 68).
(9) Tighten governor body attaching bolts to 11
N-m (8 ft. lbs.) torque.
(10) Install output shaft rear bearing in case and
install bearing snap ring. Be sure snap ring is fully
seated.
(11) Position park pawl and spring in case and in­
stall park pawl shaft (Fig. 14). Verify that spring end
is hooked to pawl and straight end of spring
(12) Install pawl shaft retaining bolt. Tighten bolt
to 27 N-m (20 ft. lbs.) torque.
RHAUL ^ — _ — — — B R
Fig. 68 Governor Snap Ring Installation
(13) Install park lock reaction plug. Note that
plug has locating pin at rear (Fig. 69). Be sure
pin is seated in hole in case before installing
snap ring.
(14) Install reaction plug snap ring (Fig. 70). Com­
press snap ring only enough for installation; do
not distort it.
REACTION
Fig. 69 Reaction Plug Locating Pin And Snap Ring
PLIERS 8921-240
Fig. 70 Reaction Plug And Snap Ring Installation