Dodge RAM TRUCK 1500 1995 Service Manual page 1514

B R — — — 46RH/47RH TRANSMISSION OVERHAUL 21 - 233
(10) Remove screws attaching pressure adjusting
screw bracket to valve body and transfer plate. Hold
bracket firmly against spring tension while removing
last screw.
(11) Remove adjusting screw bracket, line pressure
adjusting screw, pressure regulator spring and switch
valve spring (Fig. 107). Do not remove throttle
pressure adjusting screw from bracket and do
not disturb adjusting screw settings during re­
moval.
PRESSURE
REGULATOR
VALVE SPRING
ADJUSTING
SCREW
BRACKET
SWITCH
VALVE
SPRING
LINE PRESSURE
ADJUSTING SCREW
J9121-512
Fig. 107 Adjusting Screw Bracket And Spring
Removal
(12) Remove solenoid connector from 3-4 accumula­
tor housing (Fig. 108). Note that connector is at­
tached to housing with shoulder-type screw.
Keep this screw with accumulator housing to
avoid losing it.
SOLENOID
CONNECTOR
3-4
ACCUMULATOR
HOUSING
J9321-143
Fig. 108 Solenoid Connector Position
(13) Note routing of solenoid wires for assembly
reference (Fig. 109).
(14) Remove screws attaching solenoid assembly to
valve body lower housing and remove solenoid and
connector assembly (Fig. 110).
(15) Remove 3-4 accumulator housing attaching
screws and remove housing from valve body (Fig.
111).
(16) Remove following parts from valve body lower
housing: 3-4 shift valve and spring; pressure regula-
SOLENOID
WIRES
(NOTE
WIRE
ROUTING)
J932M42
Fig. 109 Solenoid Wire Routing
SOLENOID
ATTACHING
SCREWS
LOWER
HOUSING
SOLENOID
ASSEMBLY
J932M44
Fig. 110 Solenoid Assembly Removal
tor valve spring; clutch valve; clutch valve spring;
and clutch valve plug (Fig. 112).
(17) Bend back tabs on boost valve tube brace (Fig.
113). "
(18) Remove boost valve connecting tube (Fig. 114).
Disengage tube from upper housing port first. Then
rock opposite end of tube back and forth to work it
out of lower housing.
CAUTION: Do not use tools to loosen or pry the
connecting tube out of the valve body housings.
Loosen and remove the tube by hand only.
(19) Turn valve body over so valve lower housing is
facing upward (Fig. 115). In this position, check balls