Dodge RAM TRUCK 1500 1995 Service Manual page 1658

BR
Fig. 11 Seat Track Removal/Installation
Fig. 12 Seat Back
Removal
Fig. 13 Lumbar Handle Removal
(2) Remove Latch release knob (Fig. 13).
(3) Disengage J-Straps from base of seat back.
(4) Remove hogrings, if equipped.
(5) With seat back in a normal vertical position,
roll cover upwards and remove.
. — 11TER10R COMPONENTS 23 - 33
SEAT BACK COVER INSTALLATION
(1) With seat back in a normal vertical position,
roll cover downwards over seat back.
(2) Install hogrings, if equipped.
(3) Engage J-Straps at base of seat back.
(4) Align lumbar handle with lumbar cam and tap
on with rubber mallet until seated.
(5) Install Latch release knob.
SEAT CUSHION COVER REMOVAL
(1) Position seat cushion on a suitable work sur­
face with frame side up.
(2) Remove rear J-Strap.
(3) Remove Left and right J-Straps.
(4) Remove front J-Strap.
(5) Roll cushion cover off of foam cushion.
SEAT CUSHION COVER INSTALLATION
(1) Position cushion cover on cushion and roll cover
over front and rear corners. Verify stitching lines are
straight, correct as necessary.
(2) Pull front J-Strap up, align cover to foam
notches and secure front J-Strap to frame (Fig. 14).
Fig. 14 J-Strap Installation
(3) Pull the left J-Strap up and secure to frame.
Verify cover is straight.
(4) Pull the right side J-Strap pp and secure to
frame.
ASSEMBLY
(1) Align seat cushion with seat back pushing the
pivot pin on seat back through bushing on seat cush­
ion (Fig. 12).
(2) Connect rear end flap J-Straps and pull rear J-
Strap up and secure to frame.
(3) Install seat switch, if equipped.
(4) Install bolts through seat back latch into seat
cushion frame. Tighten bolts to 21.5 N-m (16 ft. lbs.)
torque.