Dodge RAM TRUCK 1500 1995 Service Manual page 1532

B R
Fig. 161 Assembling Front And Rear Clutches
Fig. 162 Intermediate Shaft Thrust Washer
Installation
(7) Align discs in rear clutch. Then install and en­
gage assembly in front planetary and driving shell
(Fig. 163). Turn clutch retainers back and forth until
both clutches are seated.
(8) Slide front band over front clutch retainer and
install front band strut and anchor (Fig. 164).
(9) Position front band lever in case and over servo
rod guide. Then install front band lever pin in case
and slide it through lever.
46RH/47RH TRANSMISSION OVERHAUL 21 - 211
Fig. 163 Front And Rear Clutch Installation
(10) Coat threads of front band pin access plug
with sealer and install it in case. Tighten plug to 17
N-m (13 ft. lbs.) torque.
LEVER STRUT
J9121-18
Fig. 164 Front Band And Linkage Installation
(11) Tighten front band adjusting screw until band
is tight on clutch retainer. Verify that front/rear
clutch assembly is still properly seated before
tightening adjusting screw.
OIL PUMP INSTALLATION
(1) Install oil pump Pilot Studs C-3288-B in case
(Fig. 165).