Dodge RAM TRUCK 1500 1995 Service Manual page 1651

23 - 26 URETHANE SET GLASS
Hg. 6 Position Urethane Compression Spacer
j'9423-212
Fig. 7 Applicator Tip
(10) Slowly lower windshield glass to the fence
opening guiding the lower corners into proper posi­
tion. Beginning at the bottom and continuing to the
top, push glass onto fence along the A-Pillars. Push
windshield i n w a r d to the fence at the bottom corners
(Fig. 8).
Fig. 8 Lower Windshield Into Position
(11) Clean excess urethane from exterior w i t h Mo­
par Super Clean or equivalent.
— — — — Eft
J9523-125
Fig. 9 Vent Window Removal/Installation
(3) Remove the frame/hinge retaining nuts from
the B-pillar.
(4) Remove the window glass f r o m the cab.
(5) I f necessary, remove the latch from the glass.
GLASS
INSTALLATION
(1) I f removed, install the latch to the glass.
Tighten the screw w i t h 6 N-m (60 i n . lbs.) torque.
(2) Center the window glass at the opening, insert
the hinge studs i n the B-pillar holes, and install the
retaining nuts. Tighten the nuts w i t h 11 N-m (95 i n .
lbs.) torque.
(3) A t t a c h the latch to the rear side panel w i t h the
screws. Tighten the screws w i t h the latch i n the lock
position and pushing rearward on the latch. Tighten
the screws w i t h 11 N-m (95 i n . lbs.) torque.
(4) Test the vent window for water leaks.
(5) I n s t a l l quarter t r i m panel.
QUARTER VENT WINDOW WEATHERSTRIP SEAL
REMOVAL
(1) Remove the window. I f necessary, refer to the
removal procedure.
(2) P u l l the seal away from the flange around the
perimeter
(12) Apply 150 m m (6 in.) lengths of 50 m m (2 in.)
masking tape spaced 250 m m (10 in.) apart to hold
molding i n place u n t i l urethane cures.
(13) Install cowl cover and wipers.
(14) I n s t a l l inside rear view mirror.
(15) After urethane has cured, remove tape strips
and water test windshield to verify repair.
QUARTER VENT WINDOW—CLUB CAB
GLASS REMOVAL
(1) Remove quarter t r i m panel.
(2) Remove the latch retaining screws from the cab
rear side panel (Fig. 9)