Dodge RAM TRUCK 1500 1995 Service Manual page 1221

BR
COMPONENT REMOVAL/INSTALLATION—DIESEL ENGINE 14 -139
INJECTOR
J9414-99
Fig. 40 Loosening injector
FUEL
INJECTOR
PULLER
TOOL*
J9414-100
Fig. 41 Removing injector with Puller Tool
COPPER
WASHER
J9114-50
Fig. 43 Injector Washer
BRUSH ANTI-
SEIZE
COMPOUND
J9414-101
Fig. 44 Apply Anti-Seize Compound
O-RING
Fig. 42 Cleaning Cylinder Head Injector Bore
o-ring located above the holddown nut (Fig. 45). After
tightening the injector, push the o-ring into the
groove on the top of the injector.
(5) Tighten the injector holddown nut to 60 N-m
(44 ft. lbs.) torque.
NOTCH J9114-51
Fig. 45 Installing Injector
(6) Connect the fuel drain manifold to the injec­
tors. Refer to Fuel Drain Manifold in this section.
(7) Connect the high-pressure fuel lines. Refer to
High-Pressure Fuel Lines in this section.