Dodge RAM TRUCK 1500 1995 Service Manual page 1694

B R
HEATING AND AIR CONDITIONING 24 - 2S
TEMP/BLEND
Fig. 16 Temperature/Blend Air Door
stall and tighten the screws.
(4) Snap on the lower center air duct.
(5) Install the heater-A/C housing into the vehicle
(refer to Heater-A/C Housing Installation).
HEAT / DEFROST DOOR ACTUATOR
REMOVAL
(1) Remove the heater-A/C housing from the vehi­
cle (refer to Heater-A/C Housing Removal).
(2) Turn the heater-A/C housing upside down.
(3) Disconnect the vacuum line (Fig. 17).
(4) Separate the door pivot connection from the
door pivot pin (Fig. 17).
(5) Remove the retaining screws.
(6) Remove the heat/defrost door actuator.
Fig. 17 Heat/Defrost Door Actuator
INSTALLATION
(1) Install the heat/defrost door actuator.
(2) Install and tighten the retaining screws.
(3) Press the door pivot connection onto the door
pivot pin.
(4) Connect the vacuum line.
(5) Install the heater-A/C housing into the vehicle
(refer to Heater-A/C Housing Installation).
HEAT / DEFROST DOOR
REMOVAL .
(1) Remove the heater-A/C housing from the vehi­
cle (refer to Heater-A/C Housing Removal).
(2) Turn the heater-A/C housing upside down.
(3) Separate the door pivot connection from the
door pivot pin.
(4) Disconnect the vacuum line.
(5) Remove the retaining screws holding the two
halves together. Remove the center adaptor heat duct
and remove the screw.
(6) Remove the bottom half of the heater-A/C hous­
ing.
(7) Remove the door.
INSTALLATION
(1) Position the door in the hole.
(2) Press the door pivot connection onto the door
pivot pin.
(3) Position the top half of the heater-A/C housing
onto the bottom. Be sure the door pivot pins align
with the pivot holes.
(4) Carefully turn the heater-A/C housing over. In­
stall and tighten the screws.
(5) Snap on the lower center air duct.
(6) Connect the vacuum line.
(7) Install the heater-A/C housing' into the vehicle
(refer to Heater-A/C Housing Installation).
PANEL / DEFROST DOOR ACTUATOR
REMOVAL
(1) Remove the heater-A/C housing from' the vehi­
cle (refer to Heater-A/C Housing Removal).
(2) Disconnect the vacuum line Fig. 18).
(3) Separate the door pivot connection from the
door pivot pin.
(4) Remove the retaining screws.
(5) Remove the panel/defrost door actuator (Fig.
18).
INSTALLATION
(1) Install the panel/defrost door actuator.
(2) Install and tighten the retaining screws.
(3) Press the door pivot connection onto the door
pivot pin.
(4) Connect the vacuum line.