Dodge RAM TRUCK 1500 1995 Service Manual page 1317

21 - 34 NV3500 MANUAL TRANSMISSION
OUTPUT
SHAFT
AND
GEARTRAIN
SPECIAL
TOOL
6747
INPUT
SHAFT
J9421-95
Fig. 95 Output Shaft And Geartrain installed In input
Shaft
OUTPUT
SHAFT
AND
GEARTRAIN
COUNTERSHAFT
(SLIDE INTO
PLACE ON
FIXTURE TOOL)
J9421-96
Fig. 96 Countershaft Installed On Fixture Tool
meshed and aligned with shaft gear teeth and
that bolt holes are facing out and not toward
geartrain. Adjust pedestal up or down if necessary.
Also be sure that short end of idler shaft is facing up
as shown.
COUNTERSHAFT
OUTPUT
SHAFT
AND
GEARTRAIN
REVERSE
IDLER
ASSEMBLY
(ON PEDESTAL)
TOOL
PEDESTAL
J9421-97
Fig. 97 Reverse Idler Assembly Positioned On
Assembly Fixture Pedestal
(12) On 2-wheel drive transmission, thread one Pi­
lot Stud C-3288-B in center or passenger side hole of
output shaft bearing retainer. Then position retainer
on fifth gear as shown (Fig. 98). Cut a screwdriver
slot at the end of the pilot stud with a hacksaw if
necessary (slot makes for easy stud removal after
housing is installed).
SPECIAL
TOOL
C-3288-B
OUTPUT
SHAFT
BEARING
RETAINER
J9421-98
Fig. 98 Positioning Output Shaft Bearing Retainer
For Rear Housing Installation
(13) Assemble 1-2 and fifth reverse-shift forks (Fig.
99). Arm of fifth-reverse fork goes through slot in 1-2
fork.