Dodge RAM TRUCK 1500 1995 Service Manual page 1450

B R
4 2 R H T R A N S M I S S I O N O V E R H A U L 2 1 - 1 6 7
LOW-REVERSE DRUM OVERRUNNING
J9121-140
Fig. 34 Checking Overrunning Clutch installation
Fig. 35 Marking Location Of Non-Threaded Hole In
Clutch Cam
Fig. 36 Pump Housing Seal Removal
(5) Remove inner and outer gears from reaction
shaft support (Fig. 39).
Fig. 37 Loosening Pump Support Bolts
J9321-213
Fig. 38 Separating Pump Housing From Reaction
Shaft Support
J9321-214
Fig. 39 Pump Gear Removal
(6) If pump seal was not removed during transmis­
sion disassembly, remove seal with punch and ham­
mer.
(7) Remove front clutch thrust washer from sup­
port hub (Fig. 40).
O i l PUMP AMD REACTION SHAFT SUPPORT
GLEAMING AND
INSPECTION
Clean pump and reaction shaft support components
with solvent and dry them with compressed air.
Inspect the pump housing and support components.
Replace the housing or support if the seal ring
grooves or machined surfaces are worn, scored, pit­
ted, or damaged.
Replace the pump gears if pitted, worn chipped, or
damaged. Inspect the thrust washer for wear or dam­
age. Replace the washer if necessary. Note that the
inner gear used in 1993 and later 42RH oil