Dodge RAM TRUCK 1500 1995 Service Manual page 1543

21 - 212 42RH/46RH/47RH OVERDRIVE OUT OVERHAUL
B R
(19) Mark position of annulus gear and direct
clutch drum for assembly alignment reference (Fig.
29). Use small center punch or scriber to make align­
ment marks.
DIRECT
CLUTCH
DRUM
PUNCH
8921-249
Fig. 29 Marking Direct Clutch Drum And Annulus
Gear For Assembly Alignment
(20) Remove direct clutch drum rear retaining ring
(Fig.
30).
INNER
RETAINING'
RING
DIRECT
CLUTCH
DRUM
ANNULUS
GEAR
J 9 1 2 1 - 2 9 2
Fig. 30 Removing Clutch Drum Inner Retaining Ring
(21) Remove direct clutch drum outer retaining
ring (Fig. 31).
(22) Mark annulus gear and output shaft for as­
sembly alignment reference (Fig. 32).
(23) Remove annulus gear from output shaft (Fig.
33). Use rawhide or plastic mallet to tap gear off
shaft.
(24) Remove output shaft front bearing if not pre­
viously removed.
OVERDRIVE COMPONENT CLEANING AND
INSPECTION
Clean the geartrain (Fig. 34) and case components
(Fig. 35) with solvent. Dry all parts except the bear­
ings with compressed air. Allow bearings to air dry.
OUTER
RETAINING RING
J 9 1 2 1 - 2 9 3
Fig. 31 Clutch Drum Outer Retaining Ring Removal
OUTPUT SHAFT-
PUNCH
J9221-46
Fig. 32 Marking Annulus Gear And Output Shaft For
Assembly Alignment
OUTPUT
SHAFT
ANNULUS
GEAR J 9 0 2 1 - 2 8 8
Fig. 33 Annulus Gear Removal
Do not use shop towels for wiping parts dry unless
the towels are made from a lint-free material. A suf-