Dodge RAM TRUCK 1500 1995 Service Manual page 1630

B R
BODY COMPONENTS 23 - 5
(2) Remove wiper arms, refer to Group 8K, Wind­
shield Wipers and Washers.
(3) Disconnect windshield washer tubing from cou­
pling near left hood hinge.
(4) Remove retainers holding cowl cover to cowl
box (Fig. 10).
COWL
P A N E L
R E T A I N E R
WINDSHIELD
WASHER
HOSE
BODY
J9423-99
Fig. 10 Cowl Cover
(5) Pull cowl seal from pinch flange a front of cowl.
(6) Separate cowl cover from vehicle.
INSTALLATION
Reverse the preceding operation.
FR01T WHEELHOUSE LINER
REMOVAL
(1) Hoist and support vehicle on safety stands.
(2) Remove front wheel.
(3) Remove plastic rivets holding wheelhouse liner
to fender at the edge of wheel opening.
(4) Remove plastic rivets holding liner to the
wheelhouse (Fig. 1).
(5) Remove plastic rivets holding liner to front
bumper fascia.
(6) Separate front wheelhouse liner from vehicle.
INSTALLATION
Reverse the preceding operation.
LEFT FRONT FENDER
REMOVAL
(1) Release hood latch and open hood.
(2)' Remove front bumper, refer to group 13,
Bumpers and Frame for procedures.
FENDER
WHEELHOUSE
LINER
PLASTIC
RIVET
J9423-18
Fig. 1 Front Wheelhouse Liner
(3) Remove battery and tray, refer to Group 8B,
Battery/Starter/Generator Service for procedures.
(4) Remove screws holding power distribution cen­
ter to left wheelhouse (Fig. 2).
ABS CONTROLLER
POWER DISTRIBUTION
CENTER
BATTERY
FENDER
BRAKE
MASTER
CYLINDER
WINDSHIELD
WASHER
RESERVOIR
J 9 4 2 3 - 9 0
Fig. 2 Left Front Fender Access Components
(5) Disengage wire harness tie-downs from wheel-
house.
(6) Remove bolts holding anti-lock brake controller
to wheelhouse (Fig. 2), if equipped. Refer to Group 5,
Brakes for procedures.