^
COMPONENT REMOVAL/INSTALLATION—EXCEPT DIESEL
14 - 81
Fig. 21 IAC Motor—3.9U5.2U5.9L
Engines—Typical
Fig. 22 IAC Motor—S.OL Engine—Typical
INTAKE MANIFOLD
Refer to Group 11, Exhaust System and Intake
Manifold for removal/installation procedures.
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
REMOVAL—3„BL
V-6 OR 5.2/5.9 L V-8
ENGINES
The MAP sensor is located on the front of the
throttle body (Fig. 21). An L-shaped rubber fitting is
used to connect the MAP sensor to throttle body (Fig.
24).
The throttle body must be removed from the
intake manifold for MAP sensor removal.
(1) Remove air cleaner assembly and tube.
(2) Remove throttle body. Refer to Throttle Body
removal in this section.
J9214-23
Fig. 23 Typical Mounting Bolts (Screws)—SAC Motor
Fig. 24 MAP Sensor L-Shaped Rubber Fitting—3.9U
5.2U5.9L
Engines—Typical
(3) Remove two MAP sensor mounting bolts
(screws) (Fig. 24).
(4) While removing MAP sensor, slide the rubber
L-shaped vacuum fitting (Fig. 24) from the throttle
body fitting.
(5) Remove rubber L-shaped fitting from MAP sen
sor.
INSTALLATION
(1) Install rubber L-shaped fitting to MAP sensor.
(2) Position sensor to throttle body while guiding
rubber fitting over throttle body vacuum fitting.
(3) Install MAP sensor mounting bolts (screws).
Tighten screws to 3 N-m (25 in. lbs.) torque.
(4) Install throttle body. Refer to Throttle Body in
stallation in this section.
(5) Install air cleaner assembly.
REMOVAL—8.0L
V-10
ENGINE
The MAP sensor is mounted into the right upper
side of the intake manifold (Fig. 25). A rubber gasket