Configuring The Collaboration Function - H3C SR6600-X Configuration Manual

Step
5. Specify the interval at
which the NQA operation
repeats.
6. Specify the probe times.
7. Specify the probe timeout
time.
8. Specify the maximum
number of hops that the
probe packets can
traverse.
9. Specify the ToS value in
the IP header of probe
packets.
10. Enable the routing table
bypass function.
11. Specify the VPN where
the operation is
performed.

Configuring the collaboration function

Collaboration is implemented by associating a reaction entry of an NQA operation with a track entry.
The reaction entry monitors the NQA operation. If the number of operation failures reaches the specified
threshold, the configured action is triggered.
To configure the collaboration function:
Step
1. Enter system view.
Command
frequency interval
probe count times
probe timeout timeout
ttl value
tos value
route-option bypass-route
vpn-instance
vpn-instance-name
Command
system-view
26
Remarks
For a voice or path jitter operation, the
default setting is 60000 milliseconds.
For other operations, the default setting is 0
milliseconds. Only one operation is
performed.
If the operation is not completed when the
interval expires, the next operation does
not start.
By default:
•
In an UDP tracert operation, the NQA
client performs three probes to each
hop to the destination.
•
In other types of operations, the NQA
client performs one probe to the
destination per operation.
This command is not available for the path
jitter and voice operations. Each of these
operations performs only one probe.
The default setting is 3000 milliseconds.
This command is not available for the path
jitter, UDP jitter, and voice operations.
The default setting is 30 for probe packets
of the UDP tracert operation, and is 20 for
probe packets of other types of operations.
This command is not available for the
DHCP and path jitter operations.
The default setting is 0.
By default, the routing table bypass
function is disabled.
This command is not available for the
DHCP and path jitter operations.
By default, the operation is performed on
the public network.
Remarks
N/A