Snmp Operation Configuration Example - H3C SR6600-X Configuration Manual

Min SD delay: 7
Number of SD delay: 410
Sum of SD delay: 3705
Square-Sum of SD delay: 45987
SD lost packets: 0
Lost packets for unknown reason: 0

SNMP operation configuration example

Network requirements
As shown in
response from the SNMP agent.
Figure 13 Network diagram
Configuration procedure
1. Assign each interface an IP address. (Details not shown.)
2. Configure static routes or a routing protocol to make sure the devices can reach each other.
(Details not shown.)
3. Configure the SNMP agent (Device B):
# Set the SNMP version to all.
<DeviceB> system-view
[DeviceB] snmp-agent sys-info version all
# Set the read community to public.
[DeviceB] snmp-agent community read public
# Set the write community to private.
[DeviceB] snmp-agent community write private
4. Configure Device A:
# Create an SNMP operation.
<DeviceA> system-view
[DeviceA] nqa entry admin test1
[DeviceA-nqa-admin-test1] type snmp
# Configure 10.2.2.2 as the destination IP address of the SNMP operation.
[DeviceA-nqa-admin-test1-snmp] destination ip 10.2.2.2
# Enable the saving of history records.
[DeviceA-nqa-admin-test1-snmp] history-record enable
[DeviceA-nqa-admin-test1-snmp] quit
# Start the SNMP operation.
[DeviceA] nqa schedule admin test1 start-time now lifetime forever
# After the SNMP operation runs for a period of time, stop the operation.
[DeviceA] undo nqa schedule admin test1
Figure 13, configure an SNMP operation to test the time the NQA client uses to get a
Min DS delay: 7
Number of DS delay: 410
Sum of DS delay: 3891
Square-Sum of DS delay: 49393
DS lost packets: 0
47