Installing The Network Scanner Kit (Option) - Kyocera Mita KM-4530 Service Manual

2BC/D

1-3-6 Installing the Network scanner kit (option)

Preparation
1. Remove three screws and remove the middle
rear B cover.
2. Remove two screws and remove the middle
rear C cover.
3. Remove four screws and remove the middle
rear cover.
4. Remove the four screws and remove the
upper sequence cover.
5. Remove the two screws and remove the
cover.
6. Firmly push connector CN1 on the scanner
board all the way into connector CN4 on the
main PCB.
7. Fasten the scanner board to the controller-
box cover with two screws.
8. Refit the covers that have been removed in
step 1 to 4.
1-3-28
Middle rear B cover
Figure 1-3-59
Cover
Upper sequence cover
Figure 1-3-60
Scanner board
Figure 1-3-61
Middle rear C cover
Middle rear cover