Kyocera Mita KM-4530 Service Manual page 67

2BC/D-1
Manual exposure adjustment (Photo)
Adjusts the exposure to be used when photo
original is selected for the image mode.
1. Select "Manual exp. adj. (Photo)" and press the
[Change #] key.
2. Press the [Lighter] or [Darker] key to adjust
default setting of copy exposure.
Setting range: -3 to +3
Margin width
Sets the default setting of the margin width for the
margin copying.
1. Select "Default margin width" and press the
[Change #] key.
2. Press the up, down, right, and left cursor keys
to set the default settings.
Setting range: 0 to 3/4" (inch specifications)
0 to 18 mm (metric specifications)
Border erase width
Sets the default setting of the border erase width
for the border erase mode.
1. Select "Default erase width" and press the
[Change #] key.
2. Press the +/- keys to adjust default erase
width.
Setting range:
Outside border:
0 to 3/4" (inch specifications)
0 to 18 mm (metric specifications)
Center area:
0 to 1 1/2" (inch specifications)
0 to 36 mm (metric specifications)
Copy limit
Sets the number of copies limit for multiple
copying.
1. Select "Preset limit" and press the [Change #]
key.
2. Press the +/- keys to set copy preset in one
job.
Setting range: 1 to 999 copies
Modify Copy
Disables the modify copy function or enables the
modify copy function in the default mode.
1. Select "Modify Copy" and press the [Change
#] key.
2. Select "On" or "Off" under "Function".
3. Select "On" or "Off" under "Default".
Job Queue Report
Sets whether or not the job queue report is
selected.
1. Select "Job Queue Report" and press the
[Change #] key.
2. Select "off", "On/All copy job" ("On/(All
copy)") or "On/reserved" ("On/reserv.job").
1-4-4
Display register key
Sets whether or not to display the Register key in
the copy operation screen.
1. Select "Display register key" and press the
[Change #] key.
2. Select "On" or "Off".
Black-line correction
Reduces black lines that may be caused when
the DF is used.
1. Select "Correct. fine black line" and press the
[Change #] key.
2. Select "On" or "Off".
Customize the base screen (main function)
Changes the layout of the main functions of the
base screen.
1. Select "Customize (Main function)" and press
the [Change #] key.
2. Change the layout to press [Move ahead] or
[Move to behind].
Customize the copy operating screen (add function)
Changes the layout of the functions except the
main functions of the copy operating screens.
1. Select "Customize (Add function)" and press
the [Change #] key.
2. Change the layout to press [ ← ].