Adjusting The Leading Edge Registration For Memory Image Printing - Kyocera Mita KM-4530 Service Manual

2BC/D-1

(6-2) Adjusting the leading edge registration for memory image printing

Make the following adjustment if there is a regular error between the leading edge of the copy image and the leading
edge of the original during memory copying.
U053 U034
(P. 1-4-20) (P. 1-6-15)
Caution
Before making the following adjustment, ensure the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "407" using the numeric keys.
Press the start key.
Press the interrupt key.
Press the start key
and make a test copy.
Is the leading edge
registration correct?
Press the stop/clear key to
exit maintenance mode.
1-6-16
U065
(P. 1-6-34, 35)
Start
No
Yes
End
U066
U407
(P. 1-6-36)
Original
example 1
Figure 1-6-33
Press the start key.
The new setting is stored.
For copy example 1, decrease the
value using the cursor down key.
For copy example 2, increase the
value using the cursor up key.
Setting range: –2.0 – +2.0
Initilal setting: 0
Changing the value by 1 moves
the leading edge by 0.1 mm.
Copy Copy
example 2