Kyocera Mita KM-4530 Service Manual page 272

2BC/D-1
(2) Detaching and refitting the DF separation pulley
Follow the procedure below to clean or replace the DF separation pulley.
Procedure
1. Open the DF original reversing cover.
2. Remove the DF front and rear covers.
3. Remove the two screws holding the upper
original feed cover and then the cover.
4. Remove the four connectors and then
remove the wires from the two wire clamps.
1-6-67-1 1-6-68
Figure 1-6-124-1
Connectors
Wire clamps
Figure 1-6-124-2
Screws
Upper original
feed cover
Connectors