Kyocera Mita KM-4530 Service Manual page 33

Removing the developing unit.
1. Open the front cover, pull out the hinge shaft to
remove, and remove the front cover.
2. Remove the screw holding the image formation
left cover and then the cover.
3. Remove the three screws and the connector that
secure the image formation unit and turn down
the paper conveying unit release lever to pull out
the image formation unit.
Hinge
shaft
Figure 1-3-8
Image formation left cover
Figure 1-3-9
Connector
Paper conveying unit
release lever
Figure 1-3-10
2BC/D
Front cover
Image formation unit
1-3-5