Kyocera Mita KM-4530 Service Manual page 253

3. Remove the transfer charger front and rear lids.
4. Remove the separation guide.
5. Replace the transfer charger cleaning pad and separation charger cleaning pad.
6. Remove the charger wire retainer pins, charger springs and then the charger wires.
Transfer
charger
rear lid
7. Wind one end of the new wire at lease five turns around the end of the charger spring.
8. Hook the other end of the charger spring onto the catch on the transfer charger terminal on the rear of the transfer
charger housing.
9. Pass the charger wire through the notches in the front and rear of the transfer charger housing, and stretch it.
10. Insert the charger wire under the charger wire retainer pin into the hole at the front of the transfer charger housing.
* The charger wire must be adjusted so that the charger spring stretches to 12.5 ± 1.5 mm.
* Cut off the excess wire under the charger wire retainer pin.
11. Refit all removed parts.
Charger
springs
Transfer charger
cleaning pad
Separation charger
cleaning pad
Figure 1-6-88
Not more than 2 mm
Not more than 1 mm
Transfer
charger terminal
Separation guide
Transfer charger
front lid
Charger
wires
Charger
pins
Charger spring
12.5 ± 1.5 mm
Charger wire
Transfer
charger terminal
Transfer charger
rear housing
Figure 1-6-89
2BC/D-1
Transfer charger
front housing
Charger wire
retainer pin
Not more than 2 mm
1-6-49