Kyocera Mita KM-4530 Service Manual page 199

2BC/D
Problem
(64) A piece of paper torn from
A paper jam in the copy paper is caught
paper feed, paper around paper feed switch
conveying or fixing 1/2/3/4/5/6, registration
section is indicated switch, feedshift switch or
on the touch panel eject switch.
immediately after
Defective paper feed
the main switch is
switch 1.
turned on.
Defective paper feed
switch 2.
Defective paper feed
switch 3.
Defective paper feed
switch 4.
Defective paper feed
switch 5.
Defective paper feed
switch 6.
Defective registration
switch.
Defective feedshift switch.
Defective eject switch.
(65) Poor contact in the con-
The message re- nector terminals of safety
questing covers to switch 1 or 2.
be closed is dis-
Defective safety switch 1
played when the
or 2.
front and right cov-
ers are closed.
(66) Wiring is broken, shorted
Others. or makes poor contact.
Noise.
1-5-52
Causes
Check and remove if any.
Run maintenance item U031 and turn paper feed switch 1 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn paper feed switch 2 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn paper feed switch 3 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn paper feed switch 4 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn paper feed switch 5 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn paper feed switch 6 on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the registration switch on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the feedshift switch on
and off manually. Replace the switch if indication of the corre-
sponding switch on the touch panel is not displayed in reverse.
Run maintenance item U031 and turn the eject switch on and off
manually. Replace the switch if indication of the corresponding
switch on the touch panel is not displayed in reverse.
Reinsert the connector. Also check for continuity within the con-
nector cable. If none, remedy or replace the cable.
Check for continuity across each switch. If there is no continuity
when the switch is on, replace it.
Check for continuity. If none, repair.
Locate the source of noise and remove.
Check procedures/corrective measures