Kyocera Mita KM-4530 Service Manual page 209

• Removing the forwarding pulley
8. Raise the forwarding pulley retainer in the
direction of the arrow, and then remove it
from the primary paper feed unit.
9. Remove the stop ring and pull the forwarding
pulley shaft in the direction of the arrow, and
then remove the forwarding pulley.
* When fitting the forwarding pulley, ensure that
the gear section engages.
• Removing the upper paper feed pulley
10. Remove the two screws and then remove the
paper feed clutch support plate and the
bushing.
Figure 1-6-7
Stop ring
Forwarding pulley
Figure 1-6-8
Bushing
Paper feed clutch support plate
Figure 1-6-9
2BC/D
Forwarding pulley retainer
Forwarding pulley shaft
1-6-5