Adjusting The Margins For Printing - Kyocera Mita KM-4530 Service Manual

2BC/D-1

(6-4) Adjusting the margins for printing

Make the following adjustment if the margins are not correct.
U403
U402
(P. 1-6-38)
Caution
Check the copy image after the adjustment. If the margins are still incorrect, perform the above adjustments in
maintenance mode.
Procedure
Start
Enter maintenance mode.
Enter "402" using the numeric keys.
Press the start key.
Select the items to be adjusted.
Press the interrupt key.
Press the start key to output a test
pattern using A3/11" × 17" paper.
Are the margins correct?
Yes
Yes
Proceed to
another mode?
No
Press the stop/clear key to
exit maintenance mode.
End
1-6-18
U404
(P. 1-6-72)
LEAD: Printer leading edge margin
A: Printer left margin
C: Printer right margin
TRAIL: Printer trailing edge margin
TRAIL (DUP): Printer trailing edge margin for
duplex copying (second face)
Press the start key.
The new setting is stored.
Change the setting.
Increasing the value using the cursor up
No
key makes the margin winder.
Decreasing the value using the cursor
down key makes the margin narrower.
Setting range (initial setting)
LEAD: 0 – +10.0 (3.5)
A: –5.0 – +10.0 (2.5)
C: –5.0 – +10.0 (2.5)
TRAIL: –5.0 – +10.0 (6.4)
TRAIL (DUP): –5.0 – +10.0 (6.4)
Changing the value by 1 moves the
margin by 0.1 mm for all.
Printer leading edge margin
(6 ± 2.5 mm)
Printer
left margin
(6 ± 2.0 mm)
Printer trailing edge margin
(6 ± 2.5 mm)
Normal copy mode
(A3/11" × 17")
Ejection direction
(reference)
Printer
right margin
(6 ± 2.0 mm)
Printer trailing edge margin
for duplex copying
(second face, A3/11" × 17")
Figure 1-6-35
(6 ± 2.5 mm)
Duplex copy mode