Adjusting Magnification Of The Scanner In The Auxiliary Scanning Direction - Kyocera Mita KM-4530 Service Manual

(8) Adjusting magnification of the scanner in the auxiliary scanning direction

Perform the following adjustment if the magnification in the auxiliary scanning direction is not correct.
U053
(main scanning
(P. 1-4-20)
direction) (P. 1-6-34)
Caution
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "065" using the numeric keys.
Press the start key.
Select "SUB SCAN ADJ"
(auxiliary scanning direction).
Press the interrupt key.
Place an original and press
the start key to make a test copy.
Is the image correct?
Press the stop/clear key to
exit maintenance mode.
U065
U065
(auxiliary scanning
direction)
Start
No
Yes
End
U070
(P. 1-6-68)
Original
example 1
Figure 1-6-67
Press the start key.
The new setting
is stored.
For copy example 1, increase the
value using the cursor up key.
For copy example 2, decrease the
value using the cursor down key.
Setting range: –25 – +25
Initial setting: 0
Changing the value by 1 changes
the magnification by 0.1%.
Increasing the value makes
the image longer, and decreasing it
make the image shorter.
Copy
Copy
example 2
1-6-35
2BC/D